There are at least two wall insertion modes one under the "Selection" tool and one in the "Insert 2D Symbol" tool. What I don't understand is why I have to toggle each independently. If I turn one off they should both turn off and vice versa. Sometimes I can turn off the wall insertion mode drop a symbol right next to a wall and rotate it. Other times I have to drop it, flip it, and then move it into place, but not before I toggle the wall insertion mode again.
[ 10-14-2003, 08:58 AM: Message edited by: David Hamer ]
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
The Hamma
There are at least two wall insertion modes one under the "Selection" tool and one in the "Insert 2D Symbol" tool. What I don't understand is why I have to toggle each independently. If I turn one off they should both turn off and vice versa. Sometimes I can turn off the wall insertion mode drop a symbol right next to a wall and rotate it. Other times I have to drop it, flip it, and then move it into place, but not before I toggle the wall insertion mode again.
[ 10-14-2003, 08:58 AM: Message edited by: David Hamer ]
Link to comment
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.