BG Posted May 10, 2002 Share Posted May 10, 2002 It would be nice if there was an additional arc tool - One that allows you to draw an arc and specify it's length. An editable box in the OI pallete that allows you to define it's length after you have drawn it would do. Quote Link to comment
0 Guest Posted May 13, 2002 Share Posted May 13, 2002 You can specify the sweep degree in the OIP for an arc. You can also specify the start and end degree. Or you can create an arc by three points where the line between the second and third point is the length of the chord of the arc. Is that not what you are looking for ? Quote Link to comment
0 BG Posted May 14, 2002 Author Share Posted May 14, 2002 Hi Katie Thanks for your reply. I want to draw an arc (or curved wall) and be able to specify the radius & the arc length (not the chord length). I have tried the arc by 3 points but I can't seem to get this tool to do that. Regards Brett Quote Link to comment
Question
BG
It would be nice if there was an additional arc tool - One that allows you to draw an arc and specify it's length.
An editable box in the OI pallete that allows you to define it's length after you have drawn it would do.
Link to comment
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.