I have been using Vectorworks for about 2 years. I works great in drawing simple floor plans and elevations. However, I still run into a problem when I am drawing a house plan with different wall heights and offsets. I get the "could not create roof, house drawing is too complex to compute" message. To create the roof, I usually trace the floor plan in a different layer, then create roof from polygon. Everything is okay until I make changes in wall heights, hip to gable, or a different pitch. I have seen some improvement in the softwares' capabilities through the upgrades, but It frustrates me when I am still receiving those messages. When is this ever going to be resolved?
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
innovative
I have been using Vectorworks for about 2 years. I works great in drawing simple floor plans and elevations. However, I still run into a problem when I am drawing a house plan with different wall heights and offsets. I get the "could not create roof, house drawing is too complex to compute" message. To create the roof, I usually trace the floor plan in a different layer, then create roof from polygon. Everything is okay until I make changes in wall heights, hip to gable, or a different pitch. I have seen some improvement in the softwares' capabilities through the upgrades, but It frustrates me when I am still receiving those messages. When is this ever going to be resolved?
Link to comment
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.