Jump to content
  • 0
Sign in to follow this  
Neil Ironside

dimensions

Question

It would be great if the smartcurser would ignore the end points of dimension lines. A typical error in my drawings has been a vertical dimension line snapping to a horizontal dimension line endpoint rather than a wall corner. Because the dimension line is offset only a few pixels from the corner, the error is sometimes difficult to notice.

Share this post


Link to post

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...