Edit Cabling Locks Up

[ktucker]

I just spent the last few days drawing out all of my facility's under-floor and above-ceiling cable tray as "Cable Routes".  I went to add drop points today and test it out.  When using "Edit Cabling" between two drop points, CC locks up, the RAM climbs above 7Gb with CPU > 25% and it just hangs.  Looking for guidance.

[Nikolay Zhelyazkov]

Hello @ktucker,

 

What version of VW are you using? Can you share a sample test file showing the issue?

 

Thanks,

Nikolay Zhelyazkov

[ktucker]

Good Morning.  Is there an email address I can send the file?  I cannot share it publicly.

 

Thank you

[Nikolay Zhelyazkov]

1 minute ago, ktucker said:

Good Morning.  Is there an email address I can send the file?  I cannot share it publicly.

 

Thank you

You can private message it to me here in the forum.

[ktucker]

I'm getting "Error Code 200" when I try and attach the file to a private message.  It's 70MB

[Nikolay Zhelyazkov]

I have sent you my email in a private message here

[Conrad Preen]

@ktucker Hi Kevin, thanks for reporting this and sharing the file with us. It's an interesting (and realistic) case where a very large number of alternative routes exist from a given drop point but without all of these being necessarily relevant. We will fix the overload issue in the next service pack and I'll give some thought to how we can further optimize these calculations.

 

Conrad