Ramon PG Posted January 30, 2023 Share Posted January 30, 2023 Where do I edit the Arch standard I am using? Quote Link to comment
0 Pat Stanford Posted January 30, 2023 Share Posted January 30, 2023 I don't think you can edit the defaults. Select the default Arch as the standard. Click the New... button and name the new standard. This should have all the same settings as the default you had active. Edit the new standard you just created. Reassign the Dimensions using the original Arch to the new one. Custom Modification is your friend for this. HTH 1 Quote Link to comment
0 Ramon PG Posted February 3, 2023 Author Share Posted February 3, 2023 On 1/30/2023 at 12:49 PM, Pat Stanford said: I don't think you can edit the defaults. Select the default Arch as the standard. Click the New... button and name the new standard. This should have all the same settings as the default you had active. Edit the new standard you just created. Reassign the Dimensions using the original Arch to the new one. Custom Modification is your friend for this. HTH Created the New and edited it later replaced the Arch with the new setting. Quote Link to comment
0 Jonathan Pickup Posted February 3, 2023 Share Posted February 3, 2023 I think the standards are not editable. After creating your new standard, make sure you set that as the default in the tool bar. That way, you will just use your new standard. Don't forget to add it to your template as well. Quote Link to comment
0 Ramon PG Posted February 3, 2023 Author Share Posted February 3, 2023 (edited) 9 hours ago, Jonathan Pickup said: I think the standards are not editable. After creating your new standard, make sure you set that as the default in the tool bar. That way, you will just use your new standard. Don't forget to add it to your template as well. I created the new standard but it is not consistent. Looks perfect in a 3/16" drawing, not so good in a 3/8" drawing. Now it seems I can't go back, I have to re-set all dims again. Replacing Dim Standards as I did above was not good. Different standards in OIP and the Custom Dimension. Confusing to me. Edited February 3, 2023 by Ramon PG Quote Link to comment
Question
Ramon PG
Where do I edit the Arch standard I am using?
Link to comment
4 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.