Technically, I should preface this by saying my problem only occurs when I try to use the inner boundary mode, and it's not in a closed area.
I know the tool isn't supposed to work when you click in an unclosed area (i.e., there's an opening in the lines), but it seems lately (I do have v2023) it's causing my program to freeze when I make this slip-up. The freeze doesn't always seem to be permanent, and I'm not even looking for a solution necessarily (although it would be nice if this was something I didn't have to think about), I'm just curious if anyone else had this problem.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Chuck97
Technically, I should preface this by saying my problem only occurs when I try to use the inner boundary mode, and it's not in a closed area.
I know the tool isn't supposed to work when you click in an unclosed area (i.e., there's an opening in the lines), but it seems lately (I do have v2023) it's causing my program to freeze when I make this slip-up. The freeze doesn't always seem to be permanent, and I'm not even looking for a solution necessarily (although it would be nice if this was something I didn't have to think about), I'm just curious if anyone else had this problem.
Link to comment
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.