LeeElston Posted November 24, 2022 Share Posted November 24, 2022 I have a slab with a hole in the middle. I can control the component offsets to the outer perimeter edges but not to the internal edges around the hole.. Is there a way of addressing this or do I need to make 4 seperate slabs to get this level of control? TIA Quote Link to comment
Tom W. Posted November 24, 2022 Share Posted November 24, 2022 You can use Clip Surface in Top/Plan to clip the desired component/s to the required offset. So use Edge Offsets to achieve the offsets around the perimeter then Clip Surface to create the offsets in the hole. Or Add/Subtract 3D Object from Slab to do the same but Clip Surface probably easier. Or you could like you say create separate Slabs + use Edge Offsets all the way around but you can do it using two Slabs rather than four... 1 Quote Link to comment
LeeElston Posted November 24, 2022 Author Share Posted November 24, 2022 Many thanks - worked a treat!! 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.