Walls Not Joined After window or door insert VW 2023

[arqmiguelhj]

Hi everyone, we are having this issue after upgrading from 2022 to 2023, any wall that we want to intersect or join, after we insert a window or door it automatically creates a cap where the join intersection shall occur, any help??....

 

Thank you in advance

[P Retondo]

At first glance, it looks like a bug.  Are the “cap” lines thinner than the wall lines?

[AlanW]

@arqmiguelhjTry using remove wall breaks over the entire wall. 

HTH

[Matt Panzer]

This is a known issue and should be resolved in an upcoming service pack.

[bpsabatier]

any update on this?  this is really a problem.

[bpsabatier]

After a little investigation, I find that if I set the wall height to 48" or less, the issue goes away.  At 49" and above, the wall connections disappear again and don't look cleaned up.  I tried setting the cut plane of the layer active and higher but that did not seem to do anything, so it might not be related to it.  

[Matt Panzer]

1 hour ago, bpsabatier said:

any update on this?  this is really a problem.

 

This should be resolved in 2023 SP1.

[zoomer]

2 hours ago, Matt Panzer said:

This should be resolved in 2023 SP1.

 

 

Is it far away ?

 

EDIT : 

Ups.... it is already there !

 

Thank you VW !

Edited October 12, 2022 by zoomer

[Matt Panzer]

34 minutes ago, zoomer said:

Is it far away ?

 

EDIT : 

Ups.... it is already there !

 

Thank you VW !

 

Yup!  It just dropped! 🙂