Search the Community
Showing results for tags 'wall projection'.
Found 6 results
-
Create Wall Feature / Projection at Intersecting Walls?
trashcan posted a question in Troubleshooting
Been out of the loop for a minute and can't remember how to create a *proper* wall feature at a corner: Results in: Instead, do I create a wall feature for each wall? Hmmm that doesn't work either. Guess I'll just do a simple extrude and class it with the walls 😕
-
Ability to add Wall Projections at corners
Christiaan posted a question in Wishlist - Feature and Content Requests
Wall Projections need to be able to work at corners of walls. I'm modelling a Mock Tudor house and was expecting to be able to use the Wall Projections feature to represent the half-timbering but can't because you can't create Wall Projections at the corner of walls. -
Hi all ! Little practical question, do you know how is it possible to use the wall projection tool on a roof profile. I'm not talking about skylight or dormer but about the wall projection tool (in my case to show the modulations and variations of steel sheet that make up the roof on the 3D). Thanks you for your help !
-
Hi, I attach a wall that has a wall feature attached to it. The wall has two components, one of the components (the brick cladding), has an offset relative to the wall of - 50 cm I'd like the wrapping of the feature component be done by the brick cladding but at the correct height. Is this possible? I tag @Alan Woodwell and @Matt Panzer as you both seem to know very well the wall tools. I would appreciate very much a hand!! Wall Projection and Component Wrap.vwx
- 5 replies
-
- 1
-
-
- wall feature
- wall
- (and 3 more)
-
I am struggling to model this part of my model. Please see attached screen shot. I have a sloped wall that meets another wall at the corner. I tried using combination of wall projection and wall recess but it is not properly. Is there a way around do this cleanly? It would be huge help if anyone can lead me to the right direction. Thank you!
-
Hi, can someone please explain me how can create a wall that has an ending which is round. I attach two images. One of the wall I would want to create in plan and in a 3D view (these have been created with an extrude, not with the wall tool). I've fiddled with AEC > Create Wall Projection but I think you can only add stuff only to the sides of the walls and not the ends.
