Search the Community
Showing results for tags 'slab drainage'.
Found 4 results
All the default drain symbols available in the Slab Drainage out of the box are roof drains. It would be good to see a few floor gullies in there too, flush with top of slab.
I typically want to define the main slope of slab drainage, not the valley slope. Currently, if I want the main slopes to be a certain figure, I need to incrementally edit the valley slopes until I get the figure I need on the main slope.
I typically want to display slope values as a rise over run (e.g. 1:80) rather than a percentage (e.g. 1.25%).
Hi all, I'm currently working on a project that includes a flat roof, and was hoping to use the slab drainage tool to give the falls to the roof, however the shape and falls of the roof is quite complex in comparison to those they cover in the tutorials. Ive tired a few times to get this to work, but no luck. I was wondering if anyone would be able to give me any pointers on using the tool to model this roof, or how to use the tool 'properly'? I've attached a screenshot of the roof shape and where i'd like the saddles/drains to be below. Thanks :) James