Search the Community
Showing results for tags 'grandma3'.
-
Helo, I did recently as follows: I created a show rig setup in Spotlight. Just fixtures in correct positions, some truss and flybars. Then I exported MVR to my GrandMA3 showfile and merged it into my file. Then I did the patch inside MA3 software, assigned correct GDTF libraries, adjusted Layering and Classing a bit and exported MVR from GMA3. I imported this adjusted MVR file into original *.vwx file. I hoped for updating information in already existing set-up, so already present fixtures get patch information, etc., but there just appeared new set of fixtures upon original ones, they all fell into one layer ignoring sorting made inside GMA and they do not have correct geometry. Is there some major wrongdoing on my side? Thanks.
-
Hello to all. I started to learn Vision 2021. I downloaded vision and Grand Ma3 onPC. However ı got some problems. I applied every directions step by step as @JuanP said ( However I couldn't update release_wiz_key_1.4.53.8.xml. because it doesn't appear any xml files. (upload the photo). Is it about ma3 onPC? I can't change the updatemode version. I think updatemode and idlemaster should be same version. (photo 2) And also i have to inform you something. I have no dongle and i have no Gma3 onPC port node. Can't i work without them? Can you please help me about this matter? Best Regards. 🙂
- 4 replies
-
- grandma3
- connection
-
(and 3 more)
Tagged with:
-
So with the release of MA3 1.0 I tried patching some GDTF files (Mac Aura XB and Encore performance) from GDTF-share, exported MVR and imported to VW 2020 sp2, screenshots below show that patchinfo got through, but I cannot believe that both those files just look like rectangles in 2d and 3d, should they not show the enclosed 3ds-model of the fixture like they use in MA? Or how is it meant to work? Do I really need to exchange all fixtures again? Was this not what GDTF was fixing? See attached ma3mvr of 2,7mb which is the export from MA. After giving them some X, Y and Z positions I wanted to export back to MA3 or Vision via MVR from VW, I get the MA export file of 1kb that does not open in Vision or MA.. So please find out what is broken with the link that was meant to fix this workflow. Next question: How do I open a GDTF-file from GDTF-share in VW? I tried importing, dragging in and now importing MVR, but it does not seem to work, so how do you do it? /Bjorn Stolt MA export.mvr ma3mvr.mvr
-
Hi ! Today I loose 12 Hours to connect Grand Ma3 ( run grandMA2 Os) to vision , without results . My question is : Is there a guide to make this ? My configuration : MA3 (grand MA 2 OS ) conected al my workstation trought a Zyxtel Switch (1Gb/s) . Ip adress of my NetworkCard : 192.168.0.220 . ip on Ma > 192.168.0.25 I changed more times all ip's. I installed 3 Time Vision 2019 Sp1 . Note: grandMA on PC connect succesfull to grandMA3 , withowt problems . Any solution
- 10 replies