Jump to content

Alan S

Member
  • Content Count

    7
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Alan S

  • Rank
    Greenhorn

Personal Information

  • Location
    North Carolina

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Wondering what I am doing wrong here. I have selected a wall to fit to three roof faces above it (in layer above it). Each roof face is at a varying height. When I run the command a variety of events occur depending on unknown factors. Is there some limit that I should be aware of in running this command for walls beneath roof faces. What I am doing doesn't seem out of the ordinary but the results are bizarre. Anyone have any suggestions?
  2. Does anyone else get this annoying message everytime VW does an autosave? The autosave seems to work fine, but this message pops up. It seems random. With some files I never see, and others it shows up everytime.
  3. I've noticed that when I am in an annotation layer I can go directly to the design layer, but when I go back to the annotation layer and then attempt to go AGAIN to the design layer, I cannot do so. I have to then exit back to the viewport and start again. It would be nice to go back and forth between annotation and design layer and then have the opportunity to step back to the viewport when I'm ready.
  4. Have to go outside VW to find this option (haven't found yet)
  5. I find it annoying that everytime I open Vectorworks, I get a blank sheet which I inevitably delete and then open the file I want. I don't see an option to eliminate this sheet on opening Vectorworks, so maybe I don't know what I am looking for, but if there is not currently an option to eliminate or have it open (as the case may be), that would be a nice feature.
  6. Is there any way to note the starting point of a polygon? It would be nice to know after working on a complex polygon where I am going to end up. I often guess, then have to go back and correct. Not a biggie but a little wish.
  7. I've never had a problem with doors until yesterday. All of a sudden the only thing showing was the casing and not the door. This occurrence was unique to one file, and not a big show stopper, but I couldn't figure out how to make the complete doors reappear. It shows up fine in 3D ... Just curious if anyone has seen this before. Vectorworks 2008

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...