ovrum

" Also, are you printing to a Postcript printer? " That was it. Thank you. I use a non-PostScript printer for my regular work, as it generally does a good job. I should have realized that I needed a PS printer for EPS files. (By the way, I needed to use the TIFF format in converting and not PICT.) Thank you for additional information. I will check it out. (I use a PowerMac upgraded to G3, Mac OS 8.6 and VW 8.5.1.) I am a member, and I did check with tech support, but they did not catch it.

Mike Conner Thanks for your reply. I have tried EPS, TIFF, JPEG and PICT, and none of them give adequate definition. PICT works well will straight lines, but complex curves get bit-mapped. Simple curves as ellipses come out OK. So far, I have had to resort to scanning in the drawings in JPEG format, but that is not satisfatory either.

I am new to this page, so the subject may have been dealt with before. Anyway, what is the best way of transferring VectorWorks drawings to a PageMaker document? My curves break up into bit-maps, and the lines in general change.