Jump to content

ronnie

Member
  • Content Count

    2
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral

About ronnie

  • Rank
    Greenhorn
  1. Nevermind everyone...I ran all the updates (11.1 & ll.5 with the service pack update) even though I couldn't get VW11 started, and that seems to have fixed this problem. I am now able to open the application with no problem.
  2. I'm having problems installing VectorWorks 11 on my computer from the installation disk. I just had to do a rebuild on my laptop, and had to put in a new hard drive and updated my operating system to Windows XP (I used Windows 2000 before). I had to reinstall VectorWorks 11 again, and after going through the whole process, everything seems to install just fine. But as soon as I try to open up VectorWorks 11, I get the following error: "This application has failed to start because BCGCBPR064.dll was not found. Re-installing the application may fix this problem." I do try to re-install the application, but still no change. Any ideas on why I'm getting this error?

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...