Jump to content

belwood

Member
  • Posts

    20
  • Joined

  • Last visited

Posts posted by belwood

  1. it's a Radeon

    I updated to SP2 a month ago- HUUGGEEEE DISASTER!

    the dongle was wiped out and i could not use VW11, i ended up reformatting my hard drive and reinstalling windows because of that stupid dongle. even after reversing out of sp2 still no luck. I refuse to update to SP2 at this point. someone sent me a solution to it but i don't trust anything now, it was such a huge ordeal i don't want to do it again.

  2. are you asking for ram memory? it's 896mb

    another note: this problem occured on my old compouter system too. i have totally overhauled my computer with a new mother board, new chip, new videocard, reinstalled windows etc. same problem different computer. The RAM chips are the only thing i have not upgraded.

  3. [Confused] Can someone tell me why my cursor keeps sticking to the "+" crosshair position after a few hours or so of working with VW11? no arrows, no hands etc. the program in general is working fine. I upgraded to a 256MB video card but that did not solve the problem. i have to restart the program and sometimes reboot computer to get normal cursor functions back.
  4. katie: yes i have all the updated drivers, which brings me to another issue, I am constantly getting runtime errors and the program crashes. this all happened when i decided to upgrade my computer to AMD64 3200, a chantech motherboard znf3-250, 400mhz ram, and geforce FX 5200/geforce MX440 video cards (running dual monitors) and updateing to SP2.. WHAT A NIGHTMARE!!! I should not have fixed what wasn't broken!

  5. i decided to go ahead and remove sp2, and i did , however it must have wiped out the dongle card, i reinstalled the aladdin software and it appearewd to install fine, but i still can not open vectorworks. i removed and reinstalled vectorworks and still no such luck. i called and spoke with tech support, no luck. i'm screwed! i will now reinstall WINDOWS, what a pain.

    ATTENTION everyone: DO NOT UPGRADE TO SP2!!!!!

  6. what a coinsidence, I was browsing this post only because it was the last one posted...30 minutes later I have this problem! I can't run VW11.01 because the dongle driver is out of date. I updated to SP2 three hours ago. Am I going to make a mistake by loading this Aladdin driver you speak of or is there a safer route?

    evrything is up to date as far as I know.

    AMD64 3200, 1gig ram

×
×
  • Create New...