Jump to content

cincykid

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About cincykid

  • Rank
    Greenhorn

Personal Information

  • Location
    United States
  1. So, in this test I made a white square just to use as a reference point. I inserted a 12"x12" stick of truss and hung it at 90 degrees (vertical). When in top/plan view, it stays where I put it, when I switch to do a fly over or change the view in 3d, it moves about a foot to the right. I also cannot rotate it around on the base as if i wanted to turn it at a 45 degree angle. truss test.vwx
  2. Since updating to 2020 when I place truss and flip it so it is standing on its end, it looks fine from the top view, but when I go to look at the drawing in 3d, it moves the truss about a foot to the right. Cant figure out why. All I am doing is creating a 10' long truss, rotating it 90 to be a ground supported tower.

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...