Jump to content

Louis Wilson

  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Louis Wilson

  • Rank

Personal Information

  • Location
  1. Hi All, i was hoping someone could help me in regards to a problem with drawing a simple circle or arc and the edge of the arc is seriously jagged. I don't think i have ever had this problem but has come to my attention in the last couple of days. When i'm in Top/plan view its fine but moving into 3d Top view or any other view the radius will go jagged, is this just normal in vectorworks? i think all my settings are correct Open GL - detail set to Very high Use Anti - Aliasing checked Navigation graphics - Good performance and compatibility 2d conversion resolution - Very high 3d conversion resolution - Very high I've also made sure my graphics card is up to date and i have Service pack 3 but it just seems weird that a simple circle in a blank document is so jagged? ive attached a screen shot of the circle and if anyone could shine some light that would be much appreciated. Thanks Louis


7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114


© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

  • Create New...