Jump to content

Will Leonard

Member
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Will Leonard

  • Rank
    Greenhorn

Personal Information

  • Location
    United States

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Jim. Thanks for the post. Do you have a link to the paper/manual MEP information you mentioned? Thanks again!!!
  2. Michael, Some of the steps you've outlined I've attempted in VW. My goal was to compare Revit functionality with VW, but once I got in to it I was surprised at the lack of information on VW MEP. I guess it will be trial and error to create a circuit that populates the panel board, then create the worksheet. Thanks for the info; it's much appreciated.
  3. Yes. I'm using VW built in equipment. Maybe I need to rephrase my question. I'm interested in tutorials on using VW MEP. So far I haven't seen much info on this. Is it in K-Base or perhaps a webinar? Either way, if you are familiar point me in the right direction. Thanks for the reply!
  4. I'm curious whether or not there is tutorial information is available for creating a quantity take-off worksheet for MEP components? (Electrical wire size and length, outlets, switches, light fixtures, etc.) So far, I haven't been able tp find much information on this topic. Any assistance on this would be appreciated.

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...