Drew Schmidt

This screen shot shows the space, one with catwalks and pipes. Highlighted in the center is one of the hanging positions "Bay 11 - Low", or the lowest pipe in that space between the catwalks. However, the pipe on the right side of the square is about 18" higher than the other three sides; but to the electricians, all four pipes / sides are the "lowest pipe in bay 11". Does that make sense?

I have a hanging position made up of multiple pipes at multiple trim heights. Creating a hanging position for each pipe would create an overwhelmingly long list; especially in paperwork. I created multiple pipes, set their Z values, selected the pipes and converted them to a hanging position. The problem comes when hanging a light; that the Z value of the light adopts the lowest Z value of the pipes that make up the hanging position. Is there something I missed? Or is this just an oversight?