I'm trying to put together a planting plan and am experiencing problems I haven't had before.
When I import a plant from the resource browser it works absolutely fine.
However, when I 'duplicate' a plant to make a new entry and then place it onto my design layer, the plant disappears and can't be selected or edited unless I close and reopen the program, or go to a sheet layer and then go back into the design layer again.
Also for some reason, these plant entry symbols are appearing smaller than the ones which I have imported from the resource browser when I view them all in the resource browser and I wondered if this is also connected to the above problem?
I'm sure the answer is obvious, but I don't know my way around VW very well! Many thanks.