Jump to content

FinchProduction

Member
  • Content Count

    7
  • Joined

  • Last visited

Posts posted by FinchProduction


  1. @JustinVH I just was puzzling with the rotation and found it. The insert point and the snap is working fine know. 

     

    The only thing I don't find is how you can connect the arc to the top or down on an other truss. 

    Like if you connect a c003 corner of prolate to a truss, you can choose the orientation of the corner leg. left, right, down and up. Is this also possible with a single circle arc?

     


  2. I'm making a circle library for the prolyte H40V series.

    I'm trying to get the insertion point @ the right spot of the  circle segment. 

    But I can't figure it out. It stays at the center beginning of the truss segment and the auto connect truss is not working properly .

     

    I real can use some help. Or is there a library with the prolate cirkels and the different segnment of them?

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...