Jump to content

NICKY WAYLO

Member
  • Content Count

    4
  • Joined

  • Last visited

Everything posted by NICKY WAYLO

  1. Make sure a clip cube is not in effect as this may cause geometry inside an object to become invisible.
  2. Has anybody discovered a way to do this using 'marionette'? I've attempted to build my own script but to no avail - perhaps someone might tell me where I'm going wrong and then we can all use the script! The script I have built (Image attached) isolates the two symbols and converts the 'PATH' to a nurbs curve. Instead of extruding however, it just seems to dump one shape on top of the other. Any help would be much appreciated. Regards
  3. Thanks for the replies Pat and Zoomer. Albeit not the result I was hoping for, good to know! If I figure out a way to do this I will post my process here. Thanks
  4. As you can see in the attached image below, VW does not want to 'solid fill' section cut my door. Does anybody know how to rectify this? Thanks in advance for your help. Regards, Dollo

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...