Jump to content

roza

Member
  • Content count

    16
  • Joined

  • Last visited

Community Reputation

0 Neutral

About roza

  • Rank
    Greenhorn

Personal Information

  • Occupation
    Architectural Designer
  • Location
    United States

Recent Profile Visitors

140 profile views
  1. Flat Roof

    Thank you!
  2. Flat Roof

    I am not able to give slope value as inches but degree... Is there any way to change degree to inches? I do a mat to figure out slope in inches...
  3. Beginner help: Do I have to create "floor slab" for to have correct "finished height"?
  4. Flat Roof

    I need help as a beginner. I couldn't figure out how to create a flat roof. To create a roof: - I draw a polyene around the wall - AEC create roof - changing the roof slope & eave/gable Then I change the slope to 0 - says "Roof pitch is not valid"
  5. Elevation View with Roof

    @JimWthank you thank you thank you!!!!
  6. Hello, I am trying to create roof with poly line. I can not see the one I already created. One roof is incorrect place. Now I can not touch any of plans, elevations... Anyone can help? Vectorworks 2017, beginner
  7. Roof 3D view

    @CipesDesignThank you. Since I am beginner its very hard
  8. Roof 3D view

    Hi all, I did create a roof but when I view 'left isometric' or 'front' etc. roof is not on the top of the wall. How I can correct? Thank you
  9. Staircase entry

    @zoomerand @Alan Woodwellthank you for the answers me from usa
  10. Hi all, I guess the arrow shows where stairs start.. I want change the starting point with ending point.. I couldn't figure out how to start to the stairs at the bottom of attached file... could you please help?
  11. Getting Started Guide - Architecture

    Could you please help me with the design layers.. why everything is floating in isometric layer view?
  12. how to save as PDF correct size

    Export from sheet layer I have a printer for 8.5X11 It might be the problem?
  13. Hi all, I was able to save as PDF is when sheet size was 11X17, but when I change the sheet size to 18X24 PDF file 18X24 but sheet is still 11X17. How to I change it?
  14. Thank you michaelk!!
  15. I am still learning vectorworks 2017. I used "create section viewport". if my file is open I can see elevation view but when I close and reopen there is nothing in elevation viewport.. could you please help?

 

    • 7150 Riverwood Drive
    • Columbia, Maryland 21046, USA
    • Contact Us | 410.290.5114

 

  • © 2018 Vectorworks, Inc. All rights reserved.
  • Vectorworks, Inc. is part of the Nemetschek Group.
×