inbinder

@Gadzooks, Yes that helps. Hopefully, I can bang this out quickly. 1) I can't quite get the same finish. Any suggestion on hatched solids? 2) Despite rotating it, it's not quite square on the design layer. I'm a few degrees skewed despite trying to rotate +/- a degree or two.

I normally do more AV schematic stuff and some electrical risers, however, I've been asked to redo this PDF and put it into vectorworks with some minor changes. I can't snap to it (scan has no vector information) which I don't think is that big of a problem. I just don't understand if I should try to draw regular lines and fill them in or use walls etc. Does anyone have any suggestions? When I try and use walls I really have no idea what I'm doing.

I'm really just looking for a building to show some structured cabling and IDF/MDF with network racks to a customer. They seem to think a pictorial representation will make this easier to digest. Thank you!

Does anyone know of any VW file(s) that are of plain, multi-floor office buildings? Thanks