Jump to content

Chris Burk

Member
  • Content Count

    7
  • Joined

  • Last visited

Community Reputation

1 Neutral

About Chris Burk

  • Rank
    Greenhorn

Personal Information

  • Location
    United States

Contact Info

  • Skype
    Chris Burk

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. This is very helpful, thanks!!
  2. Thanks. I'll give it a try
  3. How do you make a surface-sliding door that runs on a track at the top of the door?
  4. Yes, the upper portion above the pipe chase is 4' higher than the lower portion, including the Lobby. A101.pdf elevations are not drawn correctly. The left side should be 4' higher than the right side. A201.pdf
  5. I can't seem to get my walls to show in elevation at the different elevations. I have a floor that has a section at one side that is 4' below the other side. I have used the wall offset top and bottom, but it doesn't seem to affect my elevations.
  6. Thanks so much. That is exactly what happened.
  7. Why can't I snap to a point any more. I'm using VW Architect 2017.

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...