Jump to content

thelightingguy

Member
  • Posts

    6
  • Joined

  • Last visited

Posts posted by thelightingguy

  1. New question.  So I have looked all over the forum and can't find the answer anywhere.  I have a good amount of source 4s in my show file and most work fine, however a few come on, even though they are in the fixture list and look setup just like all the rest, but no light is shown.  A few others have what looks like shutters in even though I went through them all in Vectorworks and made sure that the shutters were all out.  Anyways, is there a way to modify the shutters in Vision?  I can't seem to find anything allowing that.  

     

    Thanks

     

  2. Thanks.  I updated to SP1 today and this is the first time I have seen it.  I didn't see the SP2 but I can try that and let you know if its still there.  I am using sACN which I would like to continue to do from and ION console.  The whole building runs on it so I wanted to try and keep that instead of Artnet.  

  3. I have a question.  I updated Vision to 2019 service pack 1 today and have noticed something odd that has never happened before.  Vision seems to not respond unless I move the mouse on my computer.  Has anyone ran into that before?  I didn't use to do it.  I am running on a 2018 15" MacBook Pro.  

     

    Thanks

     

  4. Thanks for the replies.  After looking through things more I think I had a bad install of Vectorworks as lots of other things started doing strange things.  So I completely removed and then reinstalled and now it is working like you are saying it should.  

     

     

  5. I have searched for a little while and can't find the answer to this.  I have Vision 2017 and Vectorworks 2017.  I haven't had to create a new model since upgrading to VW2017, but I am trying to and have an issue getting things over to vision.  In VW2015 there was a Vision library of fixtures that I could always pull from and use in VW to ensure that the lights would move over to Vision. I have not seen anything like that in VW2017 and that file from 2015 won't open in 2017.  I have all the lighting content installed, but I have placed several fixtures that don't move over to Vision. Upon looking at the Object Info Pallet I see that None is listed in the Fixture mode and it won't let me change that.  Is there a place to see just the Vision fixtures so I know what I can place in the VW drawing and have it correctly go over to Vision?  

     

    Im running SP4 in VW2017 and I just ran the updater for Vision.  

     

    Thanks

×
×
  • Create New...