Jump to content

SES_17

Member
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

About SES_17

  • Rank
    Greenhorn

Personal Information

  • Location
    CO
  1. I posted this in the General forum but moved it here since it's a Spotlight question. I've imported some new projector symbols into the "Projector Models" plug-in folder and edited the "Video Screen" tool so they can be added via the drop down menu in the OIP. I can get these new projectors to add and display ok with the exception that each one shows the projection cone off by a different amount (pic attached). Some of these new projectors were imported from the Service Select folders and others were symbols that I created with records attached. All of the default, pre-loaded projectors display properly. How do I change the projection cone location on these imported symbols?
  2. I've imported some new projector symbols into the "Projector Models" plug-in folder and edited the "Video Screen" tool so they can be added via the drop down menu in the OIP. I can get these new projectors to add and display ok with the exception that each one shows the projection cone off by a different amount (pic attached). Some of these new projectors were imported from the Service Select folders and others were symbols that I created with records attached. All of the default, pre-loaded projectors display properly. How do I change the projection cone location on these imported symbols?
  3. Running VW 2012, downloaded and extracted both Service Packs but neither installer wants to run. Splash screen still shows old build #. Can't find any Admin issues and I've been able to load and update other programs without problems. Any ideas?

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...