Jump to content


  • Content Count

  • Joined

  • Last visited

Everything posted by waveedave

  1. Hi, does anyone know how to change the angle that oblique projections are projected at? I can only get a view that projects the z-axis of the drawing at either 30 or 45 degrees on the view plane but always to the top-right. With the 'right' standard view mode this shows a section slice parallel to the view plane and the back of the object projected in oblique to the top-right, however I need it to project to the top-left so I can see front of the object in oblique projection. The isometric view modes have 8 options (right rear, left rear, lower etc.) so where is the equivalent for oblique projections? Rotating the DL 3D view or flipping a SL viewport just seem to be equivalent to switching the standard view to front or similar, but the projection always remain to the top right. Anyone got any ideas or know any work-arounds? thanks Dave


7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114


© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

  • Create New...