digitalcarbon

http://www.youtube.com/watch?v=Vjvjq9gmllY

since the "stories" posting has gone into fear and panic please see attached article from JBIM Fall2011

http://www.youtube.com/watch?v=CoXb3DsD8Go

what am i doing wrong? vw2011 http://www.youtube.com/watch?v=fdu5MP0rn_w thanks

http://www.youtube.com/watch?v=qmkRpjzUV58

does it work with a 3d connexion mouse. i looking for a way to have clients view 3d models on the screen and it would be great to fly through. i have a model of a few building and various underground utilities and would like to fly around the campus.

http://www.youtube.com/watch?v=-bbZAu4Zw0U

http://www.youtube.com/watch?v=FQZTmOiqFnI

http://www.youtube.com/watch?v=y6A2iLInykM

ok... i meant for 2012. i did a lot of modeling with the push pull tool in 2011 and found switching the active plain to be cumbersome, not any more for 2012. WOW!

http://www.youtube.com/watch?v=YE9T_u_2Uws

simple as... http://www.youtube.com/watch?v=tAR9hF2n_J4

http://www.youtube.com/watch?v=9g5bwAHTe58

1. verify existing walls, floors and model (get this right) 2. layout guide lines in plan (get this right) 3. establish treads with guide lines 4. extrude treads and set at correct height 5. make some vp sections to verify that treads work 6. establish hand rails make 3d extrude along path 7. connect rails to tread and make any corrections 8. do risers and any fancy trim etc 9. fine tune make as many section vp as needed to see every corner of this stair system do not use the stair tool

while i sure there is a difference, the big question is "is there a noticeable difference when running vw?" macmini duo core i5 or i7 or iMac quad core i5 or i7 (i hate paying for a screen since i have 2 already. that is why i like the macmini) i want to avoid paying for extra and then be told "vw does not take advantage of that yet" any comments?

yes, everything should work the same no mater what view.

a way to grab many faces http://www.youtube.com/watch?v=IdBIg-Uvi-Q

to measure i use a Stanley FatMax 77-910 TLM100 Tru Laser Measurer i can do everything by myself and with one hand, measuring that is.

a way to do it http://www.youtube.com/watch?v=Gy7PU_45Dzw

a way to do them http://www.youtube.com/watch?v=PnRIASvUBIM

i have did so a few weeks ago and also sent the file. was hoping that someone would get back to me, but no one did. so i took an hour of my time and figured it out. to be fair, i emailed it to bugsubmit@nemetschek.net is this not the way to do it?

did not have this problem in sp2 http://www.youtube.com/watch?v=9zgEk5xf6pI

a roof that looks good in plan, elevation & section http://www.youtube.com/watch?v=WM-S5m0RJQE

AndiACD, thanks for the suggestion. i'm not really stuck. there is a few ways to do it and i found a work around...but the detail cube would really be a great improvement

this is a better one http://www.youtube.com/watch?v=8xQpLCbwshY