I am new to Landmark and an attempting to figure out how to berm a structure.
I have created a site model and placed a massing model on it, half buried in the site model. I them extend a landscaping wall extending from the bottom of my massing model extending out a few feet then turning up at an angle and extending to a contour line at my desired elevation. I adjust my wall to extend over the required base and height. I then place a pad within the junction of my massing model and my landscaping walls and extending back to my desired elevation. I set my pad elevation to the desired elevation.
I cannot get the pad to build my needed contours. I have tried individual fences, using a fence over the entire area and several variations to no avail.
Any suggestions?