Jump to content

Joxley

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

1 Neutral

About Joxley

  • Rank
    Greenhorn

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi I have built a very complex 3d model which is designed into the side of a very steep gradient. I am trying to add this to the 3d site model and get the model to cut in where it reaches the building. this is very difficult to even begin to do manually using the site modifier, and I was wondering if there is a simple way of doing it - it is a series of complex spheres which are below and above the ground, so this will form a cave around the model.... I'm using 2009. Any assistance much appreciated... Cheers Jon
  2. I have a drawing which is full of symbols which have all got individual names. I am trying to display this name next to the object, so that when it is printed out our clients can refer to each item. Is this possible? Thanks...

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...