Jump to content
  • Sign in to follow this  

    Connect M-PC to Vision using Artnet


    PVA - Jim

    This post is valid for the following configurations:

    Connecting M-PC to Vision 2.3 PC via Art-net.
    Connecting M-PC to Vision 4 MAC via Art-net.

    NOTE: Currently Martin has no known method of making M-PC broadcast Art-net locally. This guide assumes a dual computer setup.

    STEP 1:

    Launch M-PC and either start a new show or open an existing file.

     

    1.jpg

    STEP 2:

    After M-PC launches, select M-PC -> Menu from the top left corner.

    2.jpg

    STEP 3:

    Select "Network", this will be near the bottom left of your screen.

     

    2_1.jpg


    STEP 4:

    Select "Interfaces", this will be towards the bottom and has a wifi icon.

    2_2.jpg

    STEP 5:

    Under Settings, select static and change the M-PC's IP address, this will change your computer's IP address as well. Click Apply. (NOTE: According to Martin support, the IP address of the machine with M-PC running MUST BE in the 2.x.x.x format and Subnet Mask MUST BE 255.0.0.0)


    2_3.jpg

     

    STEP 6:

    Finally, under EtherDMX -> Settings, verify that Artnet is turned on.

    3.jpg

    Also note that both computers MUST be in the same subnet. I.E. your vision computer must also have an ip address of 2.x.x.x and a subnet mask of 255.0.0.0.

    Edited by JimW



      Report Article
    Sign in to follow this  


    User Feedback


    There are no comments to display.



    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.
    Note: Your post will require moderator approval before it will be visible.

    Guest
    Add a comment...

    ×   Pasted as rich text.   Restore formatting

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...